+- Stresslinux community (https://www.stresslinux.org/community)
+-- Forum: Stresslinux Main (https://www.stresslinux.org/community/forumdisplay.php?fid=1)
+--- Forum: General discussion (https://www.stresslinux.org/community/forumdisplay.php?fid=2)
+--- Thread: A problem (/showthread.php?tid=14)
A problem - jolly7777 - 02-07-2007
Hi, nice work this distro.
I was looking for something like this for a long time (about 8-9 months).
I have Asus P4P800-X with Celeron 2.4ghz prescott
and P4P800 with P4 3ghz ht prescott.
On both mb it will not start the sensors (i tryed to config the sensor-detect), i cp /etc/sensors... and still couldnt start .
On tty12 it write:
"Can't access procfs/sysfs file
Unable to find i2c bus information
For kenrel 2.6make sure it has...."
The burnP6 thing will not take the Celeron to easy to 100%, and even then, it will not speed up the fan.
If i do make clean && make && make modules_install for kernel, on a gentoo distro that is compiled only for this pc (Celeron) (make -j2, march=prescott, make and gcc compiled to take advantage of any resource for this system only) it will speed up the fans in about 4-5 secs, the burnP6 did not speed up the fan for over 1 min.
Process burnP6 take about 10-12 secs until it take the cpu to load 99.x%.
On p4 it increase faster, fan speed up.
I don't care to much about sensors, but i really like to know in realtime (or 2s/update..) the temp of my cpu when running the tests, what options i do have using the latest stresslinux iso (031)?
On both mb in bios it write the cpu temp, fan speed etc, this means the mb has somkind of monitoring.
You are doing a great job!